Uninstalling The Device; Disassembling The Device; Packaging The Device; Storing The Device - Kaco blueplanet 15.0 TL3 Bedienungsanleitung

9.2

Uninstalling the device

DANGER
Dangerous voltage due to two operating voltages
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched. The
discharge time of the capacitors is up to 5 minutes.
› Only appropriately qualified electricians authorised by the mains supply network operator are permit-
ted to open and maintain the device.
› Before opening the device: Disconnect the AC and DC sides and wait at least 5 minutes.
↻ Device disconnected and secured against restart.
1 Undo the 4 screws and carefully remove the housing cover [ T_30]
2 Remove the interface cables.
3 Open the AC cable lock on the printed circuit board connection terminal.
4 Detach the equipotential bonding cable from the grounding point [ T_30]
5 Detach the interface cables from the printed circuit board connection terminal.
6 Detach from the DC cables from the DC plug connectors and furnish with protective caps.
7 Open the cable fittings [ W_46 /
8 Pull the cables out of the device.
» The device is uninstalled. Proceed with disassembly.
9.3

Disassembling the device

↻ Unit has been switched off and uninstalled.
1 Remove the screw that prevents the device from being lifted off the mount.
2 Use the lateral openings and lift the device off the mount.
» Device removed. Proceed with the packaging process.
9.4

Packaging the device

↻ Device has been uninstalled.
1 If possible, always pack the device in the original packaging. If this is no longer available, an alternative is to use equi-
valent packaging.
2 You must be able to close the box completely and it must be able to accommodate the weight and size of the device.
9.5

Storing the device

CAUTION
Property damage as a result of condensation
Faulty storage can form condensate in the device and impair the device functioning (e.g. storage outside
the ambient conditions or temporary relocation from a cold to a hot environment).
ü Store in accordance with the technical data > Environmental data [See section 4.3} Page 11]
› Prior to installation, check the inner area for condensation and if necessary, allow it to dry sufficiently
before installation.
↻ Device packaged.
F Store the device at a dry location, in accordance with the ambient temperature range Environmental data [See sec-
tion 4.3} Page 11].
Page 28
W_29 / W_19].
KACO blueplanet 15.0 TL3 KACO blueplanet 20.0 TL3