Maintenance - Concept COSMIC VP 1000 Bedienungsanleitung

EN
Note: Before inflating, make sure that the flexible hose is clean.
WARNING:
• Do not block the hole by thumb permanently,
• NEVER EXCEED THE RECOMMENDED PRESSURE. The inflated object may burst and cause injury. No
maximum pressure is indicated on soft inflating objects.
• Be careful and do not over-inflate them.
• BEFORE ANY MAINTENANCE, DISCONNECT THE VACUUM CLEANER FROM MAINS.
CLEANING THE VACUUM CLEANER AND FILTERS
Your vacuum cleaner is equipped with a transparent lid of the dust
container. When the container is full, the filters are blocked, or the
motor suction power is low and you can see that the container
is full, turn the motor off. Make sure that the accessory parts are
not blocked, the dust container full, or the filters dirty (both the
container filter and the air outlet filter). After having emptied the
container and removed the blocking objects you can turn the
motor on and continue in vacuuming.
Handle the main unit as indicated in the figure, press the release
button (1) by thumb, as indicated, open the dust container lid (2),
and remove it. Empty the dust container.
FILTERS
WARNING: Do not start the vacuum cleaner without filters.
• Your vacuum cleaner contains two graded filters in the dust
container and another filter in the air outlet.
• Before removing the filters, the motor should be turned off and
the device disconnected from mains.
• Remove the filter from the main unit by pressing on the lower
filter lock, see Fig. A.
Two filters
Ábra A
48
Transparent
lid
Container
Air outlet filter
filters
1
2
Filter 2
Filter 1
Ábra B
VP 1000
• After having removed the second-degree filter,
handle the filter and remove it according to Fig. B.
• Beat or shake dust from the filter.
• Both the filters can be cleaned by rinsing under
running water.
• Dry the filters thoroughly before inserting them back
to the main unit.
• Insert the filters using reverse procedure; make sure
that the first-grade filter is placed on the hook on the
bottom of the main unit.
• To clean the air outlet filter, open the rear port and
remove the filter from the bay.
• Wash the filter under running water and let it dry
thoroughly before inserting it back.
STORAGE
WARNING: Before winding up the cable, make sure
that it is disconnected from mains.
During storage, the electrical cable is reeled up in the bottom part of the main unit. By pulling up and turning
the snap in the bottom cover by 180º, the cable will wind up around the vacuum cleaner. The accessory parts
can be stored in the textile bag, which is included in the package.

MAINTENANCE

IMPORTANT: BEFORE ANY MAINTENANCE, DISCONNECT THE APPLIANCE FROM MAINS SOCKET.
To clean the vacuum cleaner, use common soap and a wet cloth. Avoid any liquid from penetrating the inner
parts of the vacuum cleaner; never submerge any part of the device into liquids.
Note: Before use, make sure that the vacuum cleaner is completely dry.
IMPORTANT: To ensure product safety and reliability: repairs, maintenance and
assembly (other than described in this manual) should be performed by an authorised
service centre or a qualified servicing organization.
VP 1000
EN
Snap
180°
49