Operation; Synchronising Transmitter / Receiver - Silvercrest STK 36V2 A1 Montage-, Bedienungs- Und Sicherheitshinweise

Receiver:
Remove the battery compartment cover
product.
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Open the battery compartment
cover anticlockwise.
Insert a battery (3 V
marked "+" must face upwards.
Place the battery compartment cover on the battery compartment
and tighten it by turning it clockwise.
Fasten the holder
transmitter.

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
Press the synchronisation button
(direct current), type AA).
.
9
from the back of the transmitter.
14
(direct current), type CR 2032). The side
of the transmitter back on to the back of the
14
from the back of the
8
.
9
by turning the battery compartment
13
.
2
13
GB/IE/NI 13