Messages On The Front Panel Display - Yamaha CD-NT670 Bedienungsanleitung

Troubleshooting

Messages on the front panel display

Message
Access Denied
Access Error
Initializing
Loading...
No Content
No Disc
No Songs
Not Connected
Over current
Unable to play
Version Error
52
En
Cause
Access to the PC is denied.
The unit cannot access the USB device.
There is a problem with the signal path from the network to the unit.
The unit is starting up.
The unit is loading the specified file/contents.
Selected folder does not contain playable files.
The disc set in the unit may not be supported.
The disc may be dirty, or foreign objects may be attached to it.
Disc is set upside-down.
The disc does not contain playable files.
The unit is not connected to the network.
The connected USB device is not supported by the unit.
USB device is not connected properly.
The unit cannot play back the songs stored on the USB devices or the
computer for some reason.
Firmware update is failed.
Solution
Configure the sharing settings and select the unit as a device to which
music contents are shared ( P.23).
Turn off the unit and reconnect your USB device. If the problem persists, try
another USB device.
Make sure your router and modem are turned on. Check the connection
between the unit and your router (or hub) (
Wait until the message disappears. If the message stays more than 3
minutes, turn off the unit and turn it on again.
Wait until the unit finishes loading.
Select a folder with playable files ( P.54).
Use a disc supported by the unit ( P.53).
Wipe the disc clean. Alternatively, remove foreign matters adhered to the
disc.
Set the disc with the labeled side facing up.
Set a disc with playable files ( P.53).
Check the network connection.
Disconnect the USB device, turn off the unit, and turn it on again. If this
does not solve the problem for the USB device, it is not playable on the unit.
Check if the format of files you are trying to play is supported by the unit
( P.54).
Update the firmware again.
P.12).