LIVARNO LUX HG03508A Montage-, Bedienungs- Und Sicherheitshinweise Seite 11

wall. Always observe all safety instructions
for the power drill in the manual for the power
drill. Death or injury due to electric shock may
otherwise result.
When selecting the mounting location, pay
attention to the following:
1. The solar cell requires direct sunlight when
6
possible. Ideally, the solar cell surface will be
directed to the south. The horizontal direction
of the solar cell is dependent on mounting
on a vertical wall.
2. Depending on the mounting height (ideally
at 2 m) the sensor
of max. 5m with a detection angle of 100 °
horizontally and 90 ° vertically.
3. Be sure the sensor is not illuminated by street
lighting at night. This can influence the effect.
Fix the mounting plate
rawlplugs (Ø 6 mm) and the provided
1
screws . Ensure that the arrow on the
3
marking of the mounting plate ( UP) is
showing vertically upward (Fig. A).
has a detection range
7
using the provided
2
Note: The enclosed mounting material is
suitable for ordinary masonry construction.
Other wall substrates may require other fas-
tening materials. Seek specialist advice when
in doubt.
Set the ON / OFF switch
"ON" to start the operation of the product
(Fig. G).
Note: In the "OFF" position both the light
and the charging function are disabled.
Attach the product to the mounting plate in
such a way that the hangers
mounting plate grip in the receivers
the back of the product. Slide the product
downwards until the hangers click into place
in the receivers (Fig. B).
After mounting, check that the main unit is
fitted securely.
to the position
11
of the
4
on
5
GB/CY 11