Verify Accessory Kit Installation; Care And Maintenance; Return Of Product - AtriCure CRYO1 Installationsanweisungen

6. Verify Accessory Kit Installation

WARNING: Installation of all three (3) of the Cryo1 Accessory Components is
required to the CCS–200 prior to using the AtriCure Cryo1 cryo–ablation probe. This
installation Instruction addresses only the Cylinder Pressure Temperature Display
Module.

7. Care and Maintenance

1. The CCS-200, including Cryo1 accessory components, should be handled with
the care appropriate to any precision medical instrument. Avoid banging,
dropping or mishandling the system. Periodically inspect the hoses and fittings
for any damage or wear. Other than maintaining an adequate supply of medical
grade nitrous oxide, the system is essentially maintenance free.
2. Cleaning: The control console may be wiped down with any mild soap
solution that is commonly used to clean equipment in the operating room.
Care should be exercised to use only a lightly dampened sponge when wiping
down any electronic modules such as the timers and temperature meters.
They should be wiped dry after cleaning. Under no circumstances should
solution be allowed to enter internally.

8. Return of Product

If for any reason this product must be returned to AtriCure, Inc., a return goods
authorization (RGA) number is required from AtriCure, Inc., prior to shipping.
CAUTION: It is the responsibility of the health care institution to adequately prepare
and identify the product for shipment.
If the product has been in contact with blood or body fluids, it must be thoroughly
cleaned and disinfected before packing. It should be shipped in either the original carton
or an equivalent carton, to prevent damage during shipment; and it should be properly
labeled with an RGA number and an indication of the bio-hazardous nature of the
contents of shipment.
Instructions for cleaning and materials, including appropriate shipping containers,
proper labeling, and an RGA number may be obtained from AtriCure, Inc.
7 of 56