Attaching/Removing The Brush Extension; Steam Brush Function - Silvercrest SDRB 1000 B1 Bedienungsanleitung

CAUTION
► Always remove the plug 7 from the power
socket before filling the appliance! There is a
risk of electric shock!
♦ Remove the water tank 1 by sliding back the
release 4 of the water tank 1 until you can
lift the water tank 1 up . Grip the water tank 1
by the protruding gripping aids with your thumb
and index finger and lift it up vertically . The tem-
perature control 3 stays on the appliance and
is not removed along with the water tank .
♦ Open the filler opening 2 in the water tank 1 .
♦ Use the measuring cup t to fill the water tank 1
with water to the "Max" marking .
♦ Close the filler opening 2 in the water tank 1 .
Ensure that the collar in the filler opening 2
locks into the notch on the lid . This means that
the water tank 1 is properly closed .
♦ Replace the water tank 1 onto the appliance .
The water tank 1 must audibly click into the
release of the water tank 4 .
Attaching/removing the brush
extension
CAUTION
► Never remove or attach the brush extension w
while the appliance is hot .
Risk of burns!
♦ To use the steam and brush functions, please at-
tach the brush extension w to the steam brush .
♦ To do this, push the brush extension w onto
the appliance along the guide aid until it is fully
attached . The release of the brush extension q
must click into place audibly .
♦ To use the ironing function, please remove the
brush extension w from the steam brush .
♦ To do this, push the release q downwards and
pull the brush extension w off the appliance .
SDRB 1000 B1

Steam brush function

♦ Attach the brush extension w to the appliance .
It must audibly click into the release of the brush
extension q .
♦ Insert the plug 7 into a properly installed and
grounded wall socket .
♦ To produce steam, set the temperature control 3
to ••• or higher . The heat-up indicator lamp 5
lights up . As soon as the selected temperature
has been reached, the heat-up indicator lamp 5
goes out .
NOTE
► To use the steam burst function, set the tem-
perature control 3 to ••• or higher .
Lower temperatures are insufficient for pro-
ducing a burst of steam .
♦ You can now produce a burst of steam by press-
ing the steam burst button 8 .
NOTE
► To produce the first burst of steam after heat-
ing the appliance, you may have to press the
steam burst button 8 several times in a row .
The appliance is now ready for use .
CAUTION
► The steam brush can be used with any piece
of clothing . Be careful when treating heat-
sensitive textiles such as synthetics, polyamide
or artificial silk . Before treating such materials,
first process a small test patch in an invisible
spot (inside of the seam) to ensure that the hot
steam does not damage the material . Do not
apply the hot ironing sole 0 to these materi-
als directly . Only use the steam burst function .
GB │ IE │ NI │ CY
│
7 ■