Connecting The Antennas; Connecting The Am Loop Antenna - Yamaha RX-V650 Bedienungsanleitung

Connecting the antennas

Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Indoor FM antenna
(included)
AM loop antenna
TUNER
75Ω UNBAL.
AM
FM
GND ANT
ANT
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.

Connecting the AM loop antenna

1
Set up the AM loop antenna, then connect it
to the terminals on this unit.
2
Press and hold the tab to
insert the AM loop antenna
lead wires into the AM ANT
and GND terminals.
3
Orient the AM loop antenna
for the best reception.
(included)
GND
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
75-ohm/300-ohm antenna adapter
(U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve of the
75-ohm coaxial cable and
prepare it for connection.
3
Cut the lead wire and
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
5
Snap the cover
into place.
FREQUENCY STEP switch
(Asia and General models only)
Because the interstation frequency
spacing differs in different areas, set
the FREQUENCY STEP switch
(locating on the rear panel) according
to the frequency spacing in your area.
• North, Central and South America: 100 kHz/10 kHz
• Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit's power
cord from the AC wall outlet.
CONNECTIONS
11 mm
8 mm
6 mm
Lead wire
Clamp
Clamp
Insert wire
into slot.
FREQUENCY STEP
10 H / 100 H
K Z K Z
AM FM
9 H / 50 H
K Z K Z
21