Before First Use - Silvercrest SLS 35 A1 Bedienungs- Und Sicherheitshinweise

Before first use / Operation

Before first use

Please follow the instructions
below before first use to prevent harm to the health:
Stand on a dry, non-conductive surface. Risk of
electric shock!
Ensure your hands are dry! Risk of electric shock!
Be sure your hair is dry! Risk of electric shock!
The barrels on the curling iron can become
2
very hot. Only touch the curling iron by the
handle or the Cool Touch tip when hot. Risk
9
of burns or fire!
Do not touch the barrels
Do not insert objects between the barrels
Fire hazard!
Switch the product off immediately if defective
or if malfunctions occur, and unplug from the
mains socket.
ATTENTION!
Untangle the power cord
Do not pull on, twist or kink the power cord
and do not pull or run it across sharp, pointy
objects or hot surfaces.
Do not crush the power cord
ers, doors or in the barrels
twisted power cords
electric shock!
Operation
Dry your hair completely before using the
curling iron.
Be sure your hair is clean and has no styling
products in it. This excludes thermal protection
hair products.
Comb your hair to untangle.
Plug into a suitable outlet, the LCD temperature
indicator will show „OFF".
3
Press the ON/OFF button
on. The LCD temperature display
the current temperature setting. The LCD tem-
perature display
3
iron is heating up. When the curling iron
reaches the temperature setting, the
10 GB
. Risk of burns!
2
2
if twisted.
7
in e.g. draw-
7
. Damaged or
2
increase the risk of
7
to turn the curler
6
will show
3
will flash while the curling
temperature will stop flashing and the curling
iron is ready to use.
Use the + button
desired temperature. The LCD temperature dis-
play shows the current temperature setting.
3
Press the ON / OFF switch
the temperature setting. The Lock symbol
appear in the LCD temperature display
Note: The curling iron has an automatic key-
lock which will automatically activate after
30 seconds. The curling iron cannot be
switched off until the keylock has been disabled.
To unlock, press the ON / OFF button
again. The Lock symbol
.
We recommend the following tempera-
ture settings:
Temperature
100 °C to 140 °C
140 °C to 160 °C
160 °C to 180 °C
Divide the hair into
sections approx. two
centimetres wide.
Hold the section
tight by the tips.
Carefully insert the
section of hair into the
opening between the
two metal pieces
Keep your hands far
enough from the
heating rods
or the – button
4 5
twice to save
6
will disappear.
Hair type
Fine, brittle, coloured
or bleached hair
Normal hair
Strong, resilient hair
.
2
.
2
to set the
will
.
3
twice
6