Failure Diagnositics; Warranty - Swim & Fun Easy pH Bedienungsanleitung

UK
7 FAILURE DIAGNOSTICS
SECURITIES
The device is protected by several securities:
SECURITY
LOW LED shines
LOW
HIGH LED shines
HIGH
LOW and HIGH
LEDS shine
LOW HIGH
8

WARRANTY

Important
The receipt must be presented at service calls during the warranty period. It is therefore
important that you save your sales receipt.
Before contacting your retailer, please provide the following:
• Proof of purchase.
• Serial number of the controller box and the pH probe.
• Date when the device was installed.
• Parameters of your pool (salinity, pH, chlorine rate, water temperature, stabilizing agent rate,
pool volume, daily filtration time...).
MV-1815-4-2018 . © All rights reserved Swim & Fun Scandinavia ApS
CAUSES / REMEDIES
The device has detected a pH <6.6. This value is not normal.
The CONTROL is interrupted.
Check the pH value in the pool using your usual test kit:
If the value is close to 6.6: Stop the device. Add basic pH corrector (pH too low) directly in to
the pool, in order to restore a pH near 7.2. Wait 30 minutes, restart the device and check that
HIGH
the pH returned to a value close to 7.2
If the value is far from 6.6, calibrate the pH probe (read the MAINTENANCE chapter).
The device has detected a pH > 8.0. This value is not normal.
The CONTROL is not interrupted.
Check the pH value in the pool using your usual test kit:
If the value is close to 8.0: Stop the device. Add acid pH corrector (pH too high) directly in to
the pool, in order to restore a pH near 7.2. Wait 30 minutes, restart the device and check that
the pH returned to a value close to 7.2
If the value is far from 8.0, calibrate the pH probe (read the MAINTENANCE chapter).
The unit has detected that the latest attempts to correct the pH were unsuccessful.
The CONTROL is interrupted.
Check that the pH corrective tin is not empty.
Measure manually the pH in the pool with your usual test kit and compare it with the value
indicated by the device:
If the value is different, calibrate the probe (read the MAINTENANCE chapter).
If the value is similar, contact your professional.
49