Adding/Deleting Rts Control Points And Rts Sensors; Modifying The End Limits; Modifying The Direction Of Rotation - Somfy Sunea Csi Rts Gebrauchsanleitung

7.1.2 Deleting the favourite position (my)
1) Press the "my" button: The awning moving: and stops in
the favourite position (my).
2) Press the "my" button again until the awning makes a
movement: The favourite position (my) has been deleted.

7.2 Adding/Deleting RTS control points and RTS sensors

Refer to the corresponding guide.

7.3 Modifying the end limits

The end limits are modified differently depending on type of awnings
7.3.1 Modification for cassette awnings
For cassette awnings, the upper end limit is adjusted
automatically while the lower end limit can be modified.
Reajusting the lower end limit
1) Set the awning to the set lower end limit.
2) Press the Up and Down buttons simultaneously until
the awning makes a movement : the motor is in setting
mode.
3) Adjust the lower position of the awning using the Up or
Down buttons.
4) Press the "my" button until the awning makes a
movement : the new lower end limit position has been programmed.
7.3.2 Modification for non-cassette awnings
For non-cassette awnings, the upper and lower end limits
can be modified.
Reajusting the upper end limit
1) Set the awning to the set upper end limit.
2) Press the Up and Down buttons simultaneously until
the awning makes a movement : the motor is in setting
mode.
3) Adjust the upper position of the awning using the Up or
Down buttons.
4) Press the "my" button until the awning makes a
movement : the new upper end limit has been programmed.
Reajusting the lower end limit
1) Set the awning to the set lower end limit.
2) Press the Up and Down buttons simultaneously until
the awning makes a movement : the motor is in setting
mode.
3) Adjust the lower position of the awning using the Up or
Down buttons.
4) Press the "my" button until the awning makes a
movement : the new lower end limit has been
programmed.

7.4 Modifying the direction of rotation

To modify the direction of rotation after setting the end limits, the motor's factory settings must be
restored. See the section entitled "Restoring the factory settings".
Copyright © 2009 Somfy SAS. All rights reserved.
1 2
my
1 2
3 4
or
1 2
3 4
or
1 2
3 4
Sunea CSI RTS
17