Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BEFORE FIRST USE
Before the first use it is suggested that you clean your new coffeemaker. Simply run through 2
brew cycles as described below without using coffee or a coffee filter.
USE
Unroll the power cord completely.
Check that the tension in force in the country where you are corresponds to that
indicated on the apparatus.
Connect the apparatus in a correct socket-outlet, (and connected to the ground if the
unit is Class I), to avoid any danger.
Disconnect the power source cable before any operation of cleaning of maintenance
and accessories assembly.
Never modify the appliance in anyway.
PREPARATION FOR USE
1.
Place the coffeemaker on a hard, flat surface. With the coffeemaker turned off, plug in.
2.
Fill the carafe with fresh, cold water (preferably bottled or filtered water). Open the Top
cover and pour the water into the water tank. The number of cups is shown by the water
level indicator. Do not exceed the maximum fill level. We do not recommend making
less than 4 cups.
3.
Place the carafe with the lid closed in the coffee maker making sure it is fully seated in
the coffee maker to activate the pause-n-serve mechanism.
4.
CAUTION: To avoid filter basket overflow, the carafe must fit securely into the coffee
maker with the lid on. If not properly positioned on the warming plate it could cause hot
water or hot coffee to overflow.
5.
With the Top Lid in the full opened position, insert filter, into the filter basket holder, folding
the seamed edges to insure a snug fit in the basket.
6.
Add coffee using the measuring scoop provided. Brew coffee with the coffee water
ratio you normally use when you prepare ground coffee. If you prefer strong coffee, we
recommend the following European method, which produces rich, full-bodied flavor. Use
one level scoop for each cup (6 fluid ounces) or 10 level scoops per full pot of coffee.
Experiment with the amount of coffee used in order to adjust the flavor to your taste. Do
not exceed the Max level.
7.
Close the Top Lid make sure it is securely closed.
8.
With the Top Lid firmly closed and the carafe securely in place, press the On button. The
red color LED light will light up and flashing, to indicate the brew cycle has started.
CAUTION
: Never open the Top Lid during the brewing cycle; even if no water is draining
from the Funnel. Extremely hot water/coffee can spill out from the basket and cause injury. If
water/coffee is not draining from the filter basket, IMMEDIATELY unplug the unit and wait 10
minutes before opening and checking the filter.
9.
When the brewing process ends and the water level indicator is empty, there will still be
hot liquid in the filter basket. Wait a few minutes for the rest of the liquid to drip through
into the carafe.
10. After coffee grounds have cooled, open the Top Lid and carefully remove the filter by
grasping the handle and lifting straight up from the Funnel compartment. Discard used
coffee filter and grounds.
CAUTION:
Coffeemaker becomes very hot during the brew cycle. Please handle with
extreme care.
11. The keep warm plate will operate as long as the switch is on.
5
Werbung
