Disconnecting; Answering / Ending Call; Rejecting Call; Voice Control - Silvercrest SBTH 2.1 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SBTH 2.1 A1

Disconnecting

To disconnect a device, proceed as follows:
Keep the multifunction button (2) pressed for approx. 5 seconds. The LED (3)
lights up orange twice. The device is disconnected.

Answering / ending call

Briefly press the multifunction button (2) to answer a call. To end a phone call,
press the multifunction button (2) again briefly. This is confirmed by a brief beep.

Rejecting call

To reject an incoming call, press
seconds until a beep sounds. Release
after the beep because the call will not be rejected otherwise.

Voice control

When there is an established connection, press
approx. two seconds to activate the voice control of your mobile phone.

Redialling

When there is an established connection, press
briefly to redial the number that was last called from your mobile phone.

Increasing / lowering playback volume

You can set the playback volume on your mobile phone or playback device and
also on the headphones themselves.

To increase the volume, slide the multifunction button (2) in the
The maximum volume is reached when a beep sounds.

To lower the volume, slide the multifunction button (2) in the
The minimum volume is reached when a beep sounds.
54 - English
the multifunction button (2) for approx. two
the multifunction button (2) immediately
the multifunction button (2) for
the multifunction button (2) twice
direction.
direction.