Selecting The Channel - Motorola TALKABOUT T92 H2O Handbuch

Selecting the Channel

Your radio has eight channels. The channel is the frequency the
radio uses to transmit.
1. With the radio ON, press
number starts to flash.
2. Press or to change the channel. Long press on
these keys allows you to scroll through the channels rapidly
to browse the codes.
3. Press PTT button to exit menu or
continue set up.
Note: Your radio has eight channels by default. In countries
where 16 channels are allowed, you can activate
Channels 9 to 16 with the following steps:
1.Press Menu until the channel number starts to flash.
2. Press and hold down
three seconds until you hear a beep and "16 CH" is
displayed briefly.
Note: *Only Channels one to eight are available by default.
Channels 9 to 16 need to be activated by user before
they can be selected. Channels 9 to 16 should be
used in countries where these frequencies are
allowed by government authorities. Channels 9 to 16
are not allowed in Russia.
Selecting the Interference Eliminator Code
Interference Eliminator Codes help minimize interference by
blocking transmissions from unknown sources. Your radio has
121 Interference Eliminator Codes.
To set the code for a channel:
1. Press Menu button twice until the code "9" starts to
flash.
2. Press or to select the code. You can press or hold
to speed up scrolling through the codes.
6
Menu button until the channel
Menu button to
and simultaneously for
3. Press the PTT button to exit menu or
continue set up.
Setting and Transmitting Call Tones
Your radio can transmit different call tones to other radios in
your group so you can alert them that you want to talk. Your
radio has 20 call tones for you to choose from.
To set a call tone:
1. Press Menu button three times until Call Tone
appears. The current call tone setting will flash.
2. Press or to change and listen to the call tone.
3. Press the PTT button to exit menu or
continue set up.
In order to transmit your call tone to other radios, set up the
same channel and Interference Eliminator Code on your radio
and press Call Tone button.
Voice Operated Transmission
Transmission is initiated by speaking into the microphone of the
radio instead of pushing the PTT button.
1. Press Menu button four times until
appears on the display. The current setting (L1-L3) will flash.
2. Press or to select the sensitivity level.
3. Press the PTT button to exit menu or
continue set up.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
Menu button to
icon
Menu button to
( )
icon
Menu button to