Avaya 6120 Installationsanleitung - Schnelleinstieg Seite 20

Care of your WLAN handset
• Avoid dropping the Handset or knocking it against hard sur-
faces. Carrying the Handset in a holster or carrying case will
help protect it.
• There are no serviceable parts in the Handset or Chargers.
You should not open the Handset case or disassemble the
Chargers. Doing so will void the warranty.
• Turn off the Handset and unplug Chargers before you clean
them. Take care not to exert undue pressure on Charger
electrical contacts while wiping.
• Wiping the Handset surface with a water-dampened cloth or
paper towel will remove most films or residues. If the soiling
is too stubborn for plain water, a mild detergent solution may
be used. A spray cleaner may be used with care. Do not
spray at an angle. Do not allow liquid cleaners to seep into
keypad. Be sure to wipe away any detergent residue with a
clean water-dampened cloth. Do not immerse.
• Should the headset connector become dirty, you may experi-
ence a scratchy or intermittent signal. To clean the connector,
dip the non-padded end of a wooden or paper cotton swab
stick in isopropyl alcohol. Gently insert in the connector and
twist, repeating several times. If available, blow compressed
air into the connector to clear debris.
• Keep the headset jack covered when it is not in-use.
• Using a carrying case may help protect the surfaces and help
prevent liquids (e.g., rain) from entering into the interior of the
Handset.
• If your Handset interior gets wet, do not try to accelerate dry-
ing with the use of an oven or a dryer as this will damage the
Handset and void the warranty. Instead, do the following:
1. Immediately power off the Handset.
2. Remove the Battery Pack from Handset.
3. Shake excess liquid from the Handset.
4. Place the Handset and Battery Pack in an upright position
in an area that is at room temperature and has good air-
flow.
20 English