How To Make Group Settings - Mitsubishi Heavy Industries SC-SL2NA-E Anwenderhandbuch

8. Press the SET button.
The time hour display section fl ashes.
9. Press the SELECT (
When you press
Example 1: "--:--" ⇒ You press the 10 (0) button. ⇒ "00:--" ⇒ You press the 08 button. ⇒ "08:--"
Example 2: "--:--" ⇒ You press the 01 button. ⇒ "01:--" ⇒ You press the 03 button. ⇒ "13:--"
10. Press the SET button.
The time minute display section fl ashes.
11. Press the SELECT (
You can use the GROUP No. buttons as number keys.
Example: "13:00" ⇒ You press the 02 button. ⇒ "13:02" ⇒ You press the 06 button. ⇒ "13:26"
12. Press the SET button.
The current date and time is confi rmed.
It is displayed for 2 seconds, then the display returns to normal.
Note
• To cancel a setting that is underway, press the MENU button.
• Pressing the RESET button cancels the last step.
• If the time setting is incorrect, set the correct time.
• The time is accurate to within about 10 minutes per year.

How to Make Group Settings

Set indoor units to be managed as groups as management subjects (units to be managed) for this central con-
trol.
Important
• Since the central control is shipped with all indoor units set as not being managed, always set indoor units to be
controlled by this central control as units to be managed.
Attention
• Indoor units can not be run from this central control until group settings are made.
• Do not make any group settings for two minutes after starting or stopping a unit.
or ) button or a GROUP No. button to set the time (hour).
or , fi rst 09:00 is displayed. You can use the GROUP No. buttons as number keys.
or ) button or a GROUP No. button to set the time (minute).
1
3 4
2, 5
– 7 –