How To Set Units Not To Be Managed - Mitsubishi Heavy Industries SC-SL2NA-E Anwenderhandbuch

<Changing an indoor unit number>
To change the indoor unit number and continue with individual settings, after Step 5, repeat Steps 6 and 7.
6. Press the SELECT (
7. Press the SET button.
Note
• To end the setting or to cancel settings being made, press the MENU button.
• An indoor unit set individually can not be set for program operation or other group settings from this central con-
trol. It is subject to "RUN ALL", "STOP ALL", and emergency stop input.
• If you press a GROUP No. button in 3 to 7, you can make a group setting.
• You can also make these settings from partway through group settings (Page 7).
• It is possible to set units with consecutive addresses all at once.

How to Set Units not to Be Managed

To set an indoor unit set for group or individual management to not be managed, use the following operations.
A unit set not to be managed is not even subject to "RUN ALL", "STOP ALL", and emergency stop input.
1. Press the MENU button and select
Each time you press this button, the display moves to the next step in the sequence in the diagram below.
When you select
The fl ashes.
2. Press the SET button.
The lights up and "01-00" fl ashes.
3. Press the RESET button.
The GROUP No. display section fl ashes "--".
Example: "-- - 00"
or ) button to set the indoor unit number.
1 3, 4
2, 6, 8
5, 7
, the display fl ashes.
Off
Page 11
.
– 10 –
Page 8 Step3