Names And Functions Of Parts - Mitsubishi Heavy Industries SC-SL2NA-E Anwenderhandbuch

Names and Functions of Parts

The diagram below shows the central control with its cover closed.
You can open the cover downward by placing a hand on the indentation sections on the left and right sides and
pulling toward you.
Note
The button labels comes with the central control, so write the connected group on each label and paste it in the
space above the correct button.
RUN / ERROR / PERIODIC CHECK display lamps
These display the run status for each group.
RUN: Lit up green There is at least one running indoor unit in the group.
STOP: Off All the indoor units in the group are either stopped or unregistered (not con-
nected).
ERROR: Lit up red There is at least one abnormal indoor unit in the group.
GROUP RUN / STOP buttons
These buttons run / stop the specifi ed group.
GROUP No. buttons
These are used as group selection buttons when setting the units to be managed.
When setting the date and time, they are used as the number keys.
(In that case, 11-16 are not used.)
Example: To input "09", press the 10 (0) button, then the 09 button. To input "12", press the 01
button, then the 02 button. After you have pressed the (01) then (02) buttons, if you press (03),
"23" is displayed.
Cover
STOP ALL button
Stops all the indoor units being managed.
RUN ALL button
Runs all the indoor units being managed.
LCD display section
– 3 –