Cleaning; Troubleshooting - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP74308 Konvektor LB3so Seite 9 Mittwoch, 16. Mai 2012 3:10 15
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
Fault
Appliance cannot be
switched on
Appliance switches
off automatically
Only cold air is
produced
SKD 2300 A1

7. Cleaning

8. Troubleshooting

Cause
Faulty fuse or wall socket
Faulty appliance
Thermal cut-out has
triggered
Selected temperature has
been reached
2. Remove any remaining dirt with a soft
brush.
3. Clean the outside of the appliance with a
damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
Remedy
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"Service Centre" on page 12.
Allow the appliance to cool down (see
"6.5 Thermal cut-out" on page 8)
Clean the appliance (see "7. Cleaning"
on page 9)
Appliance switches on again
automatically as soon as the room
temperature falls
Select a higher desired temperature
9