Angelo Po 08WFAAE Bedien- Und Installationshandbuch Seite 44

ADJUSTING TOP BURNER PRIMARY AIR (7KW)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of 20
mm, and tighten the screw (D).
6 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
ADJUSTING TOP BURNER PRIMARY AIR (10KW)
To carry out this operation, proceed as fol-
lows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of 20
mm, and tighten the screw (D).
6 - Replace the control panels (B) and the knobs
IT
(A) on completion of the operation.
GB
DE
FR
GREASING THE GAS TAP
To carry out this operation, proceed as follows.
ES 1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panels (B) and the knobs (A).
English
C
A C B
C
A C B
C
A C B
- 20 -
E
D
IDM-39612101900.tif
E
D
IDM-39612102000.tif
E F
D
IDM-39612102100.tif