Cleaning & Maintenance; Troubleshooting - Bosch B25L Gebrauchsanleitung

en
5. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To
obtain the best result, we recommend that this
operation is done twice
6. Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin
Intelligent steam
This ironing system has intelligent steam control,
which provides additional steam depending on the
user demand.
Cleaning & Maintenance
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
Trouble shooting
Problem Possible causes
The steam generator • There is a connection problem.
does not come on.
• The steam tank and/or main power
The iron does not • The main power button is not
heat up.
• The temperature control knob is set
The iron begins • During first use: Certain components
to smoke when
switched on.
• During later use: the soleplate may
Water flows through • The steam function is being used
the holes on the sole
plate.
• The water is condensing inside the
14
button is not switched on.
switched on.
to the «min» position.
on the appliance have been lightly
greased at the factory and may
produce a little smoke when initially
heated.
be soiled.
before it has reached temperature.
pipes because steam is being used
for the first time or has not been
used for a long time.
3. If the soleplate is soiled with dirt or scale, clean
it with a damp cloth.
4. Never use abrasive products or solvents.
Important:
• Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
Storing the appliance (D)
1. Always allow the appliance to cool down before
storing it.
2. Set the switches for main power and steam
boiler to the «Off/Stop» position and disconnect
the connection.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the water tank and store the mains cable
on the cord rewind facility. Tidy the steam hose
on the handle of the iron using the cord clip
provided (12). Do not wrap the cords too tight.
Solution
• Check the mains cable, the plug and
the socket.
• Press the buttons for main power (6)
and steam tank (4) «On/Start».
• Press the main power button (6) «On».
• Set the temperature control knob (13)
to the desired position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (3)).
• Point the iron away from the ironing
area and press the steam release
button (15) until steam is produced.