Cleaning & Maintenance - Bosch Sensixx'x DA70 SensorSecure Gebrauchsanleitung

10. After ironing

See the leaflet sides
1. Switch the steam regulator (3) from
and back again several times (self- cleaning).
2. Empty the tank. Hold the iron with the point
down and shake lightly.
3. Store standing on the rear, not on the base.
4. Do not wrap the power cord (13) too tight!
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
3 Only use steam if necessary. If possible, use
the spray function instead.
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
program.
4. If the fabrics are damp enough, turn off the
steam regulator (3) completely.
5. Stand the iron upright during pauses. Resting
it horizontally with the steam regulator on
generates wasted steam.
Cleaning & Maintenance

See the leaflet sides
E
Attention! Risk of burns!
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (7) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.
* Model dependent
All manuals and user guides at all-guides.com
2. If the cloth is synthetic, it may melt due to the
3. To keep the soleplate smooth, you should
to "max"
AntiCalc
A
Each time you use the steam regulator (3), the
"self-clean" system cleans the mechanism of
scale deposits.
B
The "Calc'nClean" function helps to remove
scale particles out of the steam chamber. Use
this function approximately every 2 weeks if the
water in your area is very hard.
1 Unplug the iron from the mains socket, set
2 Set the temperature control (12) to the "max"
3 After the necessary warm-up period, the
4 Hold the iron over a sink. Press the "clean"
5 Release the "clean" button, and gently shake
6 Repeat the steps 4 and 5 three times until the
7 Then plug the iron in and heat it up again until
Push the "clean" button a few times more to
8 Unplug the iron and let the soleplate (7) cool
high temperature on the soleplate, switch off
the steam and rub off any residue immediately
with a thickly folded, damp cotton cloth.
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.
Multiple descaling system

See the leaflet sides
self-clean
Calc'nClean
the steam regulator (3) to the
fill the water tank (11) with water.
position and plug in the iron.
"TempOK" lights inside the temperature
control (12) stop flashing. Then, unplug the
iron (very important!).
button (10) and shake the iron until
approximately one third of the water capacity
of the tank is evaporated. Boiling water and
steam will come out, carrying scale or
deposits that might be there.
the iron for some seconds.
tank is empty.
the remaining water has evaporated.
clean the valve.
down. Wipe the soleplate with a damp cotton
cloth only.
position and
17
BOSCH