Maintenance - Husqvarna 525HF3S Bedienungsanweisung

3. Hold the body of the product on the ground with your
left hand. Do not put your feet on the product.
4. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING: Do not wind the starter rope
around your hand.
5. Continue to pull the starter rope handle until the
engine starts.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. Release the starter
rope slowly to prevent damage to the
product.
6. When the engine starts, put the choke control in the
run position and apply full throttle. The throttle trigger
automatically disengages from the start position.
7. Make sure that the engine operates smoothly.
WARNING: Do not use the product with a
damaged spark plug cap to prevent
electrical shock.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
10
Note: To start the product when the engine is warm, it is
not necessary to use the choke control.
To stop the product
• Move the stop switch to the stop position to stop the
engine.
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides.
• Adjust the speed to align with the work load.
• Make sure that the engine does not touch the hedge.
• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.

Maintenance

CAUTION: The stop switch automatically
goes back to run position.
1118 - 001 - 05.09.2019