Extension Cables; Personal Protective Equipment - Husqvarna DM700 Bedienungsanweisung

conditions. Dangerous conditions, such as slippery
surfaces, can occur because of bad weather.
• Look out for persons, objects and situations that can
prevent safe operation of the product.
• When the drill points up during operation, always use
an applicable container to collect the water.
• Always attach the product to an applicable drill stand
before operation. Refer to
drill stand on page 7 .
• Make sure that you always can stop the motor
quickly in an emergency.
• Make sure that there are no pipes or electrical
cables in the area where the hole will be made.
• If the product does not operate correctly, stop the
motor.
• Make sure that you are in a safe and stable position
during operation.
• Stay at a distance from the drill bit when the motor is
on.
• Do not go away from the product when the motor is
on.
• Always disconnect the power cord before you go
away from the product.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• If vibrations occur in the product or the noise level
from the product is unusually high, stop the product
immediately. Examine the product for damages.
Repair damages or let an approved service agent do
the repair.
• Always use approved accessories. Speak to your
dealer for more information.

Extension cables

• Use only approved extension cables with sufficient
length.
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use an
extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
6
To attach the product to a

Personal protective equipment

WARNING: Read the warning instructions
that follow before you use the product.
• Always use approved personal protective equipment
when you operate the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
• Regularly do a check of the condition of the personal
protective equipment.
• Use an approved protective helmet.
• Use approved hearing protection.
• Use approved respiratory protection.
• Use approved eye protection with side protection.
• Use protective gloves.
• Use boots with steel toe-cap and non-slip sole.
• Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Fire extinguisher
• Keep a fire extinguisher near during operation.
• Use a powder fire extinguisher of "ABE" class or a
carbon dioxide fire extinguisher of "BE" type.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
1320 - 001 - 14.10.2019