Self-Timer Operation - Sony DKC-CM30 Bedienungsanleitung

Self-timer operation

2
1
A U T
O
O N
H / S /
M O D E
3 2 0 0
W B
O F F
F L A
S H
S E T
5
3
1
Set the DISPLAY switch to ON.
2
Set the PLAY/CAMERA/OFF
switch to CAMERA.
The record lamp is lit.
3
Set the WB switch and FLASH
switch according to the lighting
conditions.
When using a strobe, be sure to
set the FLASH switch to ON
(white balance at 5400K is
obatined).
When not using a strobe, set the
FLASH switch to OFF, and set
the WB switch to the appropriate
position.
4
Point the camera to the subject,
and adjust the frame, iris and
focus.
5
6
6
To interrupt a self-timer
operation
Press the release button before the
shutter is released.
Press the self-timer button.
The self-timer mark flashes on the
operation display.
Press the release button on the
camera, or the button on the
remote release.
The self-timer lamp is lit for about
seven seconds, and flashes for
about three seconds, then the
shutter is released.
When the shutter is released, the
self-timer lamp goes out, the self-
timer mark disappears, and the
self-timer operation is terminated.
45