Changing The Guard; Attaching/Removing The Accessory Tool - Parkside Performance Pwsap 20-Li B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Changing the guard
NOTE
For cut-off grinding, you must disassemble
u
the supplied guard for grinding 8
for grinding work and fit a separately
available guard for cutting-off work .
This guard must be suitable for cutting-off
u
work and can be ordered via our customer
service (article number HG03642) .
m
WARNING!
Before changing the guard for grinding
8 : Switch the product off . Remove
the battery pack 5 from the product
to prevent the product from starting
unintentionally . Let the product cool
down before making any adjustments!
Press and hold the spindle lock button 1 .
¾
Lift up and rotate the tightening tab in a
counter-clockwise direction . Release the
spindle lock button (Fig . G) .
Remove the current accessory tool (if
¾
applicable) and the backing flange 11 .
(Fig . H) .
Loosen the cover with clamp's 13 3 screws
¾
until the guard for grinding 8 can be
removed . It is not necessary to remove the
screws (Fig . I) .
Insert a new guard . The clamp must engage
¾
in one of the guard's notches . Retighten the
3 screws .
Check whether the guard can be adjusted
¾
(Fig . F) .
22 GB/CY
Reinsert backing flange 11, accessory tool
¾
and locking flange 12: Proceed in reverse
order .
NOTE
A chuck key 7 is stored inside the
u
auxiliary handle 6 . The chuck key can be
used (in addition to the tightening tab) to
loosen or tighten the locking flange 12 .
˜ Attaching/removing the
accessory tool
m
WARNING!
Always switch the product off, remove
the battery pack 5 and let the
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation .
m
CAUTION! RISK OF INJURY!
After the product has been switched off,
u
the accessory tool continues moving for
some time . Do not touch the accessory tool
and do not attempt to brake it .
m
WARNING!
Never press the spindle lock button 1
u
whilst the spindle 10 is rotating!
The arrow direction on the accessory tool
u
must be aligned with the directional arrow
( 9 or 14) .