Paper Filter (Hepa); Metal Filter; Motor Protection Filter; Exhaust Air Filter - Silvercrest SHAZ 22.2 C4 Bedienungsanleitung

9.3 Paper filter (HEPA)

The paper filter 11 sits in the filter carrier 9.
• Remove the paper filter 11 by pulling it
out upwards by the small handle in the
middle.
11
9

9.4 Metal filter

9
10
• When assembling the device, place the
filter carrier 9 straight into the dust con-
tainer 12. Ensure that it is positioned
completely straight inside the dust con-
tainer.

9.5 Motor protection filter

14
11
• To insert, place the
paper filter 11 from
above into the filter
carrier 9.
The metal filter 10 is
firmly connected to the
filter carrier 9. The filter
carrier can simply be re-
moved by the handle.
On top of the paper fil-
ter 11 sits the motor
protection filter 14.
• Remove the dust con-
tainer 12 from the
suction device 18.
The motor protection
filter 14 can then be
removed from the top
of the paper filter 11.

9.6 Exhaust air filter

21
20 19
1. To remove the filters, press the unlocking
mechanism 21 on the filter cover 20
and pull it upwards. Then, you can re-
move the exhaust air filter 19 from the
filter cover 20.
2. Insert the new exhaust air filter 19.
3. Place the rear of the filter cover 20
back onto the suction device.
4. Now press the unlocking mecha-
nism 21 on the filter cover 20 so that it
can be closed.

10. Cleaning and care

DANGER!
Pull the mains plug out of the wall socket
before you clean the device.
Allow the device to cool down before
cleaning.
CAUTION:
All parts becoming damp or wet, must
be dried completely prior to the next
use.
Do not use any sharp or abrasive clean-
ing agents.
Switch off the device prior to cleaning and
remove the battery 36.
Cleaning of the suction device
and the battery
• Use a damp, soft cloth to clean the suc-
tion device 18, the floorhead 27 and
the battery 36.
There is an exhaust air
filter 19 at the top of the
suction device 18.
GB
31