Gaggenau IK 30..-254 Montageanweisung Seite 37

If Doors 1 and 2 have overdimensions, the posi-
tion for the top edge of the template is calculated
as follows:
Top edge of door decor plus overdimension.
For fresh cooling-compartment position the tem-
plate directly against the top edge of the door.
Detach the mounting rail 12 from the refrigerator
door.
Screw on the mounting rail 12 tightly at the
centre of the decorative door in accordance with
the marked and predrilled holes (see Fig. 17).
Now hang the decorative door by hooking the
mounting rail onto the levelling screws 13. Use
the lock nuts 14 to secure the decorative panel,
as illustrated in Fig. 17.
Use the levelling screws 13 to adjust the height
and lateral alignment of the decorative door.
To do so, unscrew the levelling screws one turn.
Now fit another mounting rail 15 on the bottom
end of the decorative door, using the screws pro-
vided for this purpose. Align the decorative door
again during this process (see Fig. 17).
Decorative Doors 2 and 3 are fitted in the same
way.
Now fit the enclosed metal plates 16 to the
de-corative panel of refrigerator Door 1.
The metal plates must be fitted on the outer
edge and on the handle side of the refrigerator.
There are four drilled holes in the metal door.
Remove the screws provided to secure the inner
door to the metal door on the opposite side.
Depending on whether the decorative front is to
be split or not, you must remove four or two
screws, respectively, for the metal plates.
37