Herunterladen Inhalt Inhalt Diese Seite drucken

Elin KIA34 Handbuch Seite 18

0-2-3-4 sterne
Inhaltsverzeichnis

Werbung

fig. 11
i
FUNZIONAMENTO 2 STELLE
SBRINAMENTO
La brina che si forma sulle griglie di raffreddamento deve essere tolta quando lo
strato raggiunge uno spessore di circa 3-4 mm. perché altrimenti peggiora la trasmis-
sione del freddo e aumenta il consumo di energia. La rimozione dello strato di brina
deve essere effettuata usando l'apposito raschietto di plastica in dotazione
AVVERTENZA: non usare dispositivi | meccanici o altri metodi artificiali per accellerare il
processo di sbrinamento, diversi da quelli raccomandati dal costruttore .
Tale operazione e necessaria per garantire il buon rendimento del frigorifero ed evitare un
inutile maggior consumo di energia elettrica.
Per ottenere lo sbrinamento del frigorifero, premere il pulsante situato al centro della manopo-
la del termostato, senza spostarne la posizione (Fig. 11). L'acqua convogliata nell'apposito
recipiente, viene eliminata facendola colare dal foro, posto sul fondo, dopo aver rimosso il
tappo. Questa operazione va effettuata subito dopo aver premuto il pulsante, avendo cura di
porre al di sotto del foro, un recipiente della capacita di almeno 3/4 di litro. Si ha il reinserimento
gb
FUNCTIONING 2 STARS
DEFROSTING
The frost which forms on the cooling grids must be removed when the layer reaches a
thickness of around 3-4 mm. If this is not done, the transmission of cold is less efficient
and energy consumption is increased. The layer of frost must be removed using the
special plastic scraper supplied.
WARNING: do not use mechanical devices or other artificial means to accelerate the
defrosting process, other than those recommended by the manufacturer.
Such cleaning is very important to guarantee a good operation of the refrigerator and
avoid useless energy consumption.
In order to defrost the refrigerator, press the push-button situated at the centre of: the
thermostat knob, without changing its position (Fig. 11).
The water conveyed in the tray is eliminated by letting it drip out of the hole, placed at
the bottom, after removing the tap.
18
automatico dell'apparecchio appena terminato lo sbrinamento.
This operation is to be done directly after the push-button has-been pressed, taking care
to place a container with a capacity of a least 3/4 liters, under the hole. At the end of the
defrosting operation the refrigerator automatically starts running.
457

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis