Patek Philippe 31-260 REG QA Bedienungsanleitung Seite 20

20
quality control
The movements and completely assembled watches
are subject to a series of technical tests and visual
inspections to verify their rate accuracy, winding
speed, power reserve, reliability, water resistance,
and overall appearance. After it was assembled,
your self-winding watch will already have run for
about 14 to 30 days before leaving the workshops;
it fully complies with the stringent criteria of the
Patek Philippe Seal.
rate accuracy
The rate accuracy of Patek Philippe watches is veri-
fied in several phases of manufacturing, both with
uncased and fully cased movements. The final test
is performed with a wrist motion simulator and
the results must conform to the following Patek
Philippe precision benchmarks:
The rate accuracy of calibers with a diameter of 20 mm or
larger must range within – 3 and +2 seconds per 24 hours.
The precision of a watch is determined by how
accurately it keeps the time. A watch that is fast or
slow is considered precise if the amount by which
it is fast or slow remains constant. Such a deviation
can be easily corrected. The last test of accuracy
takes place on your wrist. Your temperament or the
nature of your physical activities can cause slight
irregularities. Fluctuations in position, temperature,
or air pressure, the presence of magnetic fields (as
produced by most electronic devices, metal detec-
tors, household appliances, etc.) as well as vibra-
tions and other factors may also affect its accuracy.
If you notice that your watch exhibits such irreg-
ularities, please do not hesitate to take it to an
Authorized Patek Philippe Retailer or an authorized
service center where no effort will be spared to
assure that it is adjusted to meet your expectations.