GM-Racing 90154.RTR Mini ST16 Nitro Truggy 4WD Bedienungsanleitung Seite 7

 Überprüfen Sie den Wagen auf verschlissene, gebrochene oder klemmende Teile und reparieren Sie
diese bei Bedarf.
 Überprüfen Sie regelmäßig den festen Sitz aller Schrauben und ziehen Sie diese gegebenenfalls
nach.
Service
In addition to the already described service work should always try your vehicle in order to keep firing to
prevent wear. If dirt in moving parts, they can this is the performance of the model significantly affect.
Remove dirt or dust with compressed air, a soft brush and / or with a toothbrush. If possible, try using no
solvents, as this is in fact the dirt in the camps and in the normally inaccessible places and thus cause
additional wear. We recommend the following simple procedures:
• Remove dirt and dust as far as possible with the methods described above.
• Keep the fuel never longer than two hours in the tank.
• Take the conclusion of a racing day, the tank empty. Build the air filter and drip a little WD-40 or any
other quality After Run-Oil in the carburetor and turn off the engine a few times.
• If necessary, clean the air filter and oil it again before you put it back into the car fitted.
• Check the car on worn, broken or gripping parts and repair them if necessary.
• Check regularly the fixed seating all screws and tighten them if necessary.
Service und Reparaturen
In Problemfällen oder bei Fragen und Reparaturen, wenden Sie sich bitte an:
GRAUPNER-Service, Henriettenstrasse 94-96, D-73230 Kirchheim/Teck,
Tel. +49/1805/472876
Service and repair
In problem cases, or for questions and repairs, please contact:
GRAUPNER-Service, Henriettenstrasse 94-96, D-73230 Kirchheim/Teck,
Tel. +49/1805/472876
MINI ST16 NITRO
7