Power Supply; Completing The Installation; Commissioning - AEG DDLE Basis 18/21/24 Bedienungs- Und Installationsanleitung

Never replace the pressure limiter when using a thermostatic valve.
Never use the shut-off valve in the cold water supply (22) to reduce the fl ow rate.
3.7

Power supply

STB = High limit safety cut-out
AP3 = Safety pressure limiter
Important information:
and if the cable sheath is sealed correctly.
For supply cables > 6 mm², increase the hole in the cable grommet.
3.8

Completing the installation

Click the lower part of the back panel (
3.9

Commissioning

1
Open and close all connected taps several times, until all air
Air - see "2.3 Important information".
2
The instantaneous water heater is delivered with the safety
pressure limiter triggered (press the reset button).
3
4
5
6
7
"7. Troubleshooting"):
red illuminates in case of faults
green fl ashing - equipment is supplied with mains power
with its operation.
3) into place.
E
9), see also
A
For contractors
I ).
1
2
3
L3 '
4
L2 '
1
L1 '
2
4
5
2.
1.
6
or )
G K
3
29