Power Consumption - Axis P1365-E Installationsanleitung

AXIS P1365-E Network Camera
Important
When the ambient temperature is below 0 ºC (32 ºF), start-up could take up to 60 minutes.
The colder it is, the longer the start-up.

Power Consumption

NO TICE TICE
NO NO TICE
Use a limited power source (LPS) with either a rated output power limited to ≤100W
or a rated output current limited to ≤5A.
Product
AXIS P1365–E
Connectors
I/O Connector
4–pin terminal block for:
• Auxiliary power (DC output)
• Digital Input
• Digital Output
• 0 V DC (-)
Function Pin
1
0 V DC (-)
2
DC output
3–
Configurable
4
(Input or
Output)
PoE
Power over Ethernet (PoE) IEEE 802.3af/802.3at
Type 1 Class 3, max. 12.95 W, typical 4.4 W
Notes
Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
Digital input – Connect to pin 1 to activate,
or leave floating (unconnected) to deactivate.
Digital output – Connected to pin 1 when
activated, floating (unconnected) when
deactivated. If used with an inductive load,
e.g. a relay, a diode must be connected in
parallel with the load, for protection against
voltage transients.
1
2 3 4
14
Specifications
0 V DC
12 V D C
Max load = 50 mA
0 to max 30 V DC
0 to max 30 V DC, open
drain, 100 mA