Access The Product - Axis P1365-E Installationsanleitung

AXIS P1365-E Network Camera
12. If using a sunshield (sold separately), place it over the top cover, adjust its position
and tighten the screws.

Access the Product

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Adjust Focus
To adjust the zoom and focus follow these instructions:
Note
• Set focus as precisely as possible with the focus puller or Focus Assistant before starting
automatic fine tuning. Using the focus puller normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of field and thus the best conditions for correct focusing.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers (see Hardware Overview on page 8) on the lens by
turning them counter-clockwise. Move the pullers to set zoom and focus and check
the quality of the image in the image window. If the camera is mounted so that one
cannot look at the image and move the pullers at the same time, use the Focus Assistant
instead. See Focus Assistant on page 25.
5. Re-tighten the zoom and focus pullers.
6. On the Focus page, click Fine-tune focus automatically and wait until automatic fine
tuning is completed.
7. Click Enable iris. If the button is inactive the iris is already enabled.
8. If needed, make further adjustments under the Advanced tab. See the online help for
more information.
24