Clas Ohlson MW-1328 Bedienungsanleitung Seite 6

Remote control tips:
• Point the remote control directly at the Bluetooth speaker, making sure that
you are within range (max 3 m).
• If either the Bluetooth speaker or remote control is exposed to strong sunlight
the signals between them may be blocked.
Operating instructions
1. Connect the mains lead to the adaptor and then connect the adaptor lead
to the Bluetooth speaker.
2. Plug the adaptor into a wall socket.
3. The Bluetooth speaker's LED indicator (7) will show red to indicate that
it is in standby mode.
Bluetooth playback
Note: The Bluetooth speaker may only be synced to one device at a time.
1. Press [ ►ll ]. The LED indicator will flash blue which indicates that the speaker
is available for pairing.
2. Activate Bluetooth on the device to be paired and place it into search mode.
3. The Bluetooth speaker will appear as "MW-1328BT" on your device. Select
this as the device to be connected. Refer to your device's instruction manual
if you are unsure. Note: If you are prompted to enter a PIN code, you should
enter "0000" (four noughts). Certain devices may even require you to approve
the connection.
4. Once connection has been established the speaker's LED will show a steady blue.
5. Start playback on the paired device.
6. Adjust the volume both on the device and speaker to achieve the desired
volume level.
Aux-in playback
1. Press [ ►ll ]. The LED indicator will flash blue which indicates that it is available
for pairing.
2. Press [ M ] until the LED indicator is a steady green.
3. Connect your device to the 3.5 mm AUX IN jack (10) on the speaker's back panel.
4. Start playback on the device.
5. Adjust the volume both on the device and speaker to achieve the desired
volume level.
Note: The [ ►ll ], [ ►►l ] and [ l◄◄ ] controls on the speaker will not work as long
as your device is connected to the AUX IN jack. Playback must be controlled from
the connected device.
6