Setting Up The Clock; Wall Mounting; Switching Bluetooth Connection On/Off; Displays During Brushing - Nevadent NZAOT 600 A1 Bedienungsanleitung

6. Press the button 30. The tens digit of
the minutes flashes in the display 27.
7. Repeatedly press the button 31 to set
the time in 10 minute intervals.
8. Press the button 30. The singles digit of
the minutes flashes in the display 27.
9. Repeatedly press the button 31 to set
the time in one minute intervals.
10. Press the button 30. The time is now
set.
11. Place the battery compartment cov-
er 28 onto the clock 26 and press it
down.

5.3 Setting up the clock

1. Figure B: press the clock 26 into the
housing.
2. Place the clock 26 on a flat surface.

5.4 Wall mounting

1. Figure B: press the clock 26 into the
housing.
2. Remove one of the protective films from
the ring 32 and stick it onto the wall
mount 33.
3. Clean the smooth surface (e.g. mirror,
wall tile) to which you wish to apply the
wall mount.
4. Remove the other protective film and
stick the wall mount to the surface.
5. Mount the clock 26 in the housing on
the wall mount.
5.5 Switching Bluetooth con-
nection on/off
The toothbrush 11 is connected to the
clock 26 via Bluetooth. This connection is al-
ready switched on when supplied.
24 GB
Switching off Bluetooth
Switch off the Bluetooth connection e.g. if
you are not using the clock 26 and you wish
to spare the battery.
1. Switch on the toothbrush 11 using the
on/off switch
switch it off again.
2. Hold down the button P 8 for approx.
3 seconds and additionally briefly
press the on/off switch
flashes rapidly 4 times in white. The Blue-
tooth connection has now been broken.
When you switch the toothbrush 11 on
again, the LED 6 will no longer be lit.
Switching on Bluetooth
1. Switch on the toothbrush 11 using the
on/off switch
switch it off again.
2. Hold down the button P 8 for approx.
3 seconds and additionally briefly
press the on/off switch
flashes rapidly 4 times in white. The Blue-
tooth connection is now switched on.
When you switch the toothbrush 11 on
again, the LED 6 will be lit and the con-
nection to the clock 26 will be restored
after approx. 10 seconds.
5.6 Displays during brush-
ing
• When the Bluetooth connection is
switched on, the timer automatically
starts when you begin brushing your
teeth.
• The display 27 shows the intervals dur-
ing brushing as corners. The display be-
gins in the top right of the display 27,
and moves round clockwise after each
30 second interval.
• During brushing, the display 27 shows
the symbol of the active mode.
• After 2 minutes, the display 27 shows
a smiley.
7 and then immediately
7. The LED 6
7 and then immediately
7. The LED 6