Spare Parts; Operation; Technical Data - HANSGROHE Allegra Premia 16804000 Montageanleitung

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink. Hole Ø 36 mm!
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metall without the
plastic washer.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the hose with hose nut, taper sleeve,
disc and washer.
7. Mount the hose weight - be careful by the max.
drawn out, otherwise the hose could be crack.
Large differences in pressure between the hot and
cold water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right =
cold water.
The handspray can be drawn approx. 50 cm out of
the arm lining. The spray mode is changed to
showerspray or normal spray by turning the diverter
ring. The diffusor channels are automatically cleaned
by shifting regulary the spray mode.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature: 65° C
Rate of flow by 3 bars aerated spray: 11 l/min
Rate of flow by 3 bars shower spray:
with back flow prevention
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
English

Spare parts

1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
12 l/min
handle
flange
nut
cartridge cpl.
service set
seals (5)
mixer ball
hose
handspray
areator cpl.
fixation cpl.
16891880
94186000
95046880
94106000
14095000
13952000
13962000
13964000
95048000
16893880
13085000
95049000