Spare Parts; Technical Data - HANSGROHE Metris 31400000 Montageanleitung/Garantie

Assembly
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right =
cold water.
31400000: The flow is changed from bath to
shower function by pulling the knop at the upper
side of the spout. After shutting off the water flow,
the mixer returns automatically to the bath function.

Technical Data

Operating pressure:
Recommended operating pres.: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp: 65° C
Centre distance:
Connections G ½":
Rate of flow:
back flow and vacuum breaker
To adjust the hot water limiter on single lever mixers,
please see page 2.
No adjustment is necessary when using a
continuous flow water heater.
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
6
max. 10 bars
16 bars
max. 80° C
150 ± 16 mm
cold right - hot left
approx. 22 l/min 3 bars
English

Spare parts

1 handle for 31400000
1.1 screw cover for 31400000
2 flange
3 nut
4 service set
5 seals
6 mixer ball
7 cartridge cpl.
8 escutcheon
9 S - unions
10 aerator cpl.
11 selector
12 diverter knob
13 handle for 31600000
13.1 screw cover for 31600000
31091000
94186000
94130000
94106000
13952000
13962000
13964000
14096000
94135000
94140000
13485000
94103000
94102000
31491000
94189000
6