Spare Parts - HANSGROHE AXOR Carlton 17032 Serie Montageanleitung/Garantie

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by turning the handles,
left = hot water, right = cold water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1,5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the flow limiter (3a)
located behind the mousseur must be removed.
All manuals and user guides at all-guides.com
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
English

Spare parts

1 knob for cold water Carlton
knob for cold water Mondaro
2 knob for hot water Carlton
knob for hot water Mondaro
3 mousseur cpl.
4 Elastop stop unit
5 pull rod cpl. Carlton
pull rod cpl. Mondaro
6 fixation cpl.
XXX = Colors
Carlton
000 chrome plated
090 chrome/gold plated
810 satinox
840 fine brass
Mondaro
000 chrome plated
010 chrom / gold / jewel
090 chrome/gold plated
490 white/gold plated
840 fine brass
17291XXX
18291XXX
17292XXX
18292XXX
13085000
94149000
94028XXX
92620XXX
13961000