Herunterladen Diese Seite drucken

Maxi-Cosi Mica Gebrauchsanweisung Seite 65

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 69
A - Seat cover
B - Adjustable headrest
C - Newborn inlay - exclusively for use with
Mica from 40 to 60 cm
D - 5-point Harness
E - Removable shoulder pads
F - Harness buckle
G - Harness adjuster button
H - Harness adjuster strap
I - Recline handle
J - Rotation handle
K - Support leg indicator
L - Support leg
M - Support leg adjuster button
N - Support leg height adjustment rack
O - Headrest adjustment handle
P - G-CELL
Q - Backrest ventilation
R - ISOFIX connectors
S - ISOFIX clips activation handle
T - User manual storage compartment
U - Battery compartment
SAFETY
• The Mica is intended for car use only.
• The Mica is developed for an intensive use of
approximately 12 years.
• Do not use any load bearing contact points
other than those described in the instructions
and marked in the child restraint.
The Mica car seat in the car:
• The car seat can be rotated 360° to help you
get your child in and out of the vehicle easily. This
also allows you to change the position of the seat
from rearward facing to forward facing.
• Before buying this product make sure the car
seat is compatible with the vehicle it is to be
used in.
• The car seat must be installed with ISOFIX and
support leg.
• The support leg must always be unfolded
completely, locked and placed in the most forward
position.
• When the child restraint is installed in the
maximum rearward facing position, it may not
fit in all approved vehicles. Please check that
all possible positions of the car seat (recline
positions and headrest adjustment) fit in your car.
Your child in the Mica car seat
• The newborn inlay included in your Mica seat
plays an integral part in the efficiency of the
restraint system for your child from 40 to 60
cm. It can be removed and the cover taken off
for washing, but it is essential to place it back
again where it belongs and only use this official
Maxi-Cosi Mica newborn inlay. This newborn inlay
is exclusively for use with the Mica seat.
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm).
If there is more space than 1 cm, tighten the
harness belt further.
• Make sure the headrest is adjusted to the proper
height.
WARNING:
• The car seat must always be locked in the
forward facing or rearward facing position
EN
I
I
Maxi-Cosi
Mica
65

Werbung

loading