Carrying Out The Blood Pressure Measurement - Silvercrest SBM69 Gebrauchsanleitung Und Sicherheitshinweise

Confirm your choice using the START / STOP button
or wait 3 seconds. Your choice will then be
8
saved automatically.
Carrying out the blood
pressure measurement
Place the cuff on your arm as previously described and
assume the position in which you wish to carry out the
measurement.
Switch on the blood pressure monitor using the START /
STOP button
After the full-screen display, the last measurement result saved
will be displayed. If no measurement has been saved, the de-
vice will display the value of "0".
After 5 seconds, the blood pressure monitor will begin with
the measurement by pumping up the cuff. The measurement
is taken while the cuff is being pumped up. As soon as a pulse
has been detected, the pulse symbol
After this, the cuff air pressure will be released again.
The measurement results for systolic pressure, diastolic pres-
sure and pulse will be displayed.
You can stop the measurement at any time by pressing
the START / STOP button
If the measurement has not been carried out correctly,
"Er_" will be displayed (see "Troubleshooting" also).
Repeat the measurement process in the event that this
happens.
The measurement result will be saved automatically.
.
8
.
8
will be displayed.
GB 23