Troubleshooting; Possible Cause - Silvercrest SPLB 44 A1 Bedienungsanleitung Und Sicherheitshinweise

Troubleshooting

This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage. The following table
will help you to identify and rectify minor malfunctions:
Fault
There is nothing
on the display .
No sound.
Interference
occurs during
radio reception.
The Bluetooth
®
connection cannot
be established.
No sound is
produced by the
microphone.
■ 42 │ GB │ IE

Possible cause

The integrated battery is
empty.
The socket is not supplying
any power.
The main switch is set
to the position.
The volume is set to
minimum.
The device is not in the
required operating mode.
The reception is too weak.
The Bluetooth
®
connec-
tion is not activated on your
playback device.
Another playback device is
still paired with the device.
The distance between the
device and the playback
device is too great.
The microphone has not
been correctly connected.
The volume is set to minimum.
The microphone is not
switched on.
Remedy
Plug the power plug into the socket to
recharge the integrated battery.
Check the house fuses.
Set the main switch
Increase the volume using the
dial
Press the button
have selected the required operating
mode.
Try to improve reception by moving
the FM wire aerial
Make sure that the Bluetooth
function is activated on the playback
device.
If you use several playback devices,
ensure that any previous connection
is disconnected. There may be a
previously paired playback device still
within range.
Ensure that the device is no more than
10 metres away from the playback
device.
Ensure that the microphone is correctly
connected to one of the two 6.3 mm
jack sockets
Increase the volume using the
dial
Slide the On/Off switch
to the position to switch the micro-
phone on.
to the position.
.
until you
.
®
/ .
.
SPLB 44 A1