Technical Characteristics; Installation Instructions - Climadiff VSV12F Gebrauchsanweisung

3. TECHNICAL CHARACTERISTICS

Below is an example of the nameplate:
The name plate attached to the inside or rear of the appliance (depending on the model) includes all the
information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you can
refer to it later (technical work, request for assistance, etc.)
Once it is installed and loaded, access to it is not so easy.
CAUTION: No assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using your appliance
 Remove the inner and outer packaging.
 Allow the appliance to rest for two hours before switching it on.
 Clean the inside using a soft cloth and lukewarm water.
Using your temperature control cellar
The appliance must be positioned in a room with an ideal ambient temperature of 25°C.
If the ambient temperature is higher or lower, the appliance's performance may be affected.
Installing your appliance
 This appliance is designed for free-standing installation.
 Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
 To get the best from your appliance with the lowest energy consumption, do not place the appliance close
to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a room
which is too cold.
 Connect the appliance to a single socket, leaving a 10 cm gap between the back of it and the wall and 2
cm on each side. Be careful to support it, so that it is perfectly level. (Use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and will
ensure that the door seals perfectly.
22