Maintenance - Climadiff VSV12F Gebrauchsanweisung

Selecting the temperature
You can choose the desired temperature in the compartment, using the
selected increases/decreases by 1°C with each button press.
This appliance belongs to category 10 according to the european regulation N°1060/2010. The temperature
setting is from 14° to 18°C.
However the appliance's technical performances allow to reach a wider temperature range from 12° to 18°C.
The interior light may be switched on or off using the

5. MAINTENANCE

Before cleaning your appliance (something that should be done regularly), disconnect it by removing the plug
or by pulling the fuse on the circuit.
Before using your appliance for the first time and regularly after that, we recommend that you clean the
inside and outside (front, sides and top) with warm water mixed with a gentle cleaning product. Rinse with
clean water and allow to dry before reconnecting. Do not use solvents or abrasives.
In the event of a pronounced plastic smell, clean the appliance with a mixture of two tablespoons of
bicarbonate of soda, mixed in a ¼ litre of lukewarm water.
When the appliance is switched on for the first time, there may be a residual odour. In that case, run the
appliance empty for a few hours at the coldest possible temperature. The cold will kill any odours.
6. STORING YOUR TEMPERATURE CONTROL CELLAR
If you will not be using your appliance for short periods, leave the control panel with its usual
settings.
During an extended shutdown:
- Remove all bottles from the appliance
- Unplug the appliance
- Thoroughly clean the inside and outside of the appliance
- Leave the door open to prevent condensation, unpleasant odours and mould
7. WHAT TO DO IN THE EVENT OF A POWER CUT
Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will not affect the temperature
inside your appliance. To protect your drinks during power cuts, remember to open the door as little as
possible. For long duration power cuts, take necessary steps to protect your food/drinks.
8. IF YOU NEED TO MOVE YOUR APPLIANCE
 Remove all contents and secure movable components.
 To avoid damaging the levelling screws on the feet, screw them tightly into the base.
 Move the appliance in an upright position (preferably) or take note of the direction in which the
appliance may be laid down by looking at its packaging.
9. IN THE EVENT OF A BREAKDOWN
Despite the care we take during production, a breakdown can never be totally ruled out. Before contacting
your retailer's after-sales department, please check that:
 The appliance is properly plugged in
 There is not a power cut in progress
 The breakdown is not one of those described in the table at the end of this manual
/ buttons. The temperature
button.
23