MO-EL BLACKLIGHT series Gebrauch Und Wartung Seite 10

brackets provided or supplied as fittings.
Under no circumstances turn the appliance on if it is on the floor or
•
on a surface that does not ensure adequate heat emission.
The appliance must not be recessed in the ceiling. There must be
•
enough space around the top of the appliance to ensure adequate
aeration. Use only the brackets supplied or the optional ones to fix
the appliance.
A minimum air gap of 30 cm should always be allowed between
•
the top of the heater and a ceiling or roof. The appliance should be
50 cm far from the walls (fig. 1 and 4).
A safety distance of not less than 100 cm should always be left in
•
front of the Blacklight heaters or too near.
This unit should be mounted at a minimum of 180 cm above ground
•
level (fig. 1). If installed in a toilet, the height should be 225 cm in
zone 1 and zone 2; in zone 3 the minimum above ground level is
180 cm, according with the rules of each Country.
The appliance must not be located neither directly below, nor in
•
front of a socket-outlet.
The heater must be installed so as to prevent that the switches can
•
be touched from those who are in the shower.
Ensure that there is no possibility of inflammable material, com-
•
bustible material or curtains coming into contact with the heater,
or lie near the heater.
The product is in class I and IP55, wich is the protection rate for
•
the units to be used even outdoor. For keeping the protection rate
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP55 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988.
3. FITTING
Before being used, the heater must be fixed to the wall or to the
ceiling by means of the provided supports, as described below.
Before drilling the holes for the dowels, be sure that the wall is sol-
id and that you are far from water tubes or electrical wires. Be sure
that the heater is not facing the ceiling or inflammable materials.
10