Specifications; Important Safety Instructions - Makita AT2550A Betriebsanleitung

ENGLISH
(Original instructions)
1 Compressor air output per
minute
2 Stapling frequency (times/min)
3 Depth adjusting plate
4 Hex wrench
5 Hook
6 Screw
7 Lock pin

SPECIFICATIONS

Model
Air pressure
Applicable staples
Staple capacity
Min. hose diameter
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003

IMPORTANT SAFETY INSTRUCTIONS

WARNING: WHEN USING
SAFETY PRECAUTIONS SHOULD ALWAYS BE FOL-
LOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and main-
tenance of the tool, read this instruction manual
before using the tool.
• Always wear safety glasses to protect your eyes
from dust or staple injury.
WARNING:
It is an employer's responsibility to enforce the use
of safety eye protection equipment by the tool
operators and by other persons in the immediate
working area.
• For Australia and New Zealand only
Always wear safety glasses and face shield to pro-
tect your eyes from dust or staple injury. The safety
glasses and the face shield should conform with
the requirements of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use
of safety eye protection equipment by the tool
operators and by other persons in the immediate
working area.
Explanation of general view
8 Pusher
9 Air fitting
10 Air socket
11 Trigger
12 Contact element
13 Workpiece
14 Exhaust cover
15 Driver guide
AT1150A
370 mm x 87 mm x 290 mm
1.8 kg
ENB103-1
THIS TOOL, BASIC
16 Latch
17 Slotted bit screwdriver
18 Latch
19 Door
20 Drain cock
21 Air filter
22 Oiler
23 Pneumatic oil
0.44 – 0.83 MPa (4.4 – 8.3 bar)
25 mm – 50 mm
140 pcs.
6.5 mm
370 mm x 76 mm x 260 mm
Safety glasses
Face shield
• Wear hearing protection to protect your ears
against exhaust noise and head protection. Also
wear light but not loose clothing. Sleeves should
be buttoned or rolled up. No necktie should be
worn.
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when
under the influence of alcohol, drugs or the like.
General Tool Handling Guidelines:
1. Always assume that the tool contains fasteners.
2. Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
3. Do not activate the tool unless the tool is placed
firmly against the workpiece.
4. Respect the tool as a working implement.
5. No horseplay.
6. Do not hold or carry the tool with a finger on the
trigger.
7. Do not load the tool with fasteners when any one
of the operating controls is activated.
8. Do not operate the tool with any power source
other than that specified in the tool operating/
safety instructions.
• An improperly functioning tool must not be used.
AT2550A
2.2 kg
7