Mounting The Direct Disposal Pipe; Initial Filling And Leak Test - Kessel EasyClean free Basic Anleitung Für Einbau, Bedienung Und Wartung

3.4

Mounting the direct disposal pipe

Only for conversion to system type Direct
For optimum sealing, do not deburr the drilling edges.
• Screw fastening clamps onto the retainers on the tank .
• Make drillhole in the tapping area (hole saw, Ø 121 mm) .
• Insert the passage seal into the drillhole. 
• Insert the direct disposal pipe into the passage seal and mount the
fastening clamps. 
• Connect fabric hose with 2 pipe clamps and 10 Nm torque
onto PE pipe DN 70 with bead. 
If connecting to a steel pipe, ensure a restrained
joint.
3.5

Initial filling and leak test

• Perform leak test, to do so:
• Open both service access covers. If the service access covers are
difficult to open, insert a flat screw driver in the groove and lever open
carefully.
• Make sure that there are no external materials or soiling in the grease
separator.
• Use suitable means to close off the outlet and inlet.
• Fill grease separator completely with water and make sure that there
are no leaks.
• Restore functional capability of the outlet and inlet.
The system is now ready for use.
2019/07


3x 3x
23 /88



Fig. [3]
Fig. [4]
010-296