Organisational Safety Measures; Product-Specific Safety Instructions; Installation; Recommendations For The Installation Location / Operation - Kessel EasyClean free Basic Anleitung Für Einbau, Bedienung Und Wartung

2.3

Organisational safety measures

The operating and maintenance instructions must always be kept near the grease separator.
2.4

Product-specific safety instructions

2.4.1 Risk of slipping when the system is emptied
During cleaning work, greasy liquid and/or grease can wet the floor. This results in a slipping hazard. Always remove
any liquid and/or grease that has leaked immediately, and wear suitable footwear.
2.4.2 Risk of infection in case of contact with the wastewater
The wastewater contains bacteria. There is a risk of infection in the event of contact with mucous membranes,
eyes, wounds or when absorbed into the body. If any parts of the body come into contact with wastewater, clean
immediately and change contaminated clothing. Wear personal protective equipment.
2.4.3 Safe lifting and transport
To avoid damage to the tank, the product may only be moved if it is fixed on a transport pallet. The system may only be
transported by means of a fork-lift truck, which grips the transport pallet. Lifting the system in any other way or moving
it by means of a crane is not allowed.
2.4.4 Wear personal protective equipment
- Protective clothing, protective gloves
- Goggles, safety footwear
3

Installation

3.1

Recommendations for the installation location / operation

– Room with good air supply and/or ventilation as well as a level installation area with adequate load-bearing capacity.
– Room temperature at least 15° C.
– Sealed flooring with integrated drain.
– Hot and cold water connections
– Room height at least 60 cm higher than the grease separator, so that the service access cover can be opened for
cleaning work.
– Free working space, at least 1 m, in front of the grease separator.
– Inlet with stilling section of at least. 1 m (slope 1:50). Transition of on-site downpipe to calming section equipped with
2 x 45° bends.
– If the inlet pipe is longer than 10 m, it must be vented separately.
2019/07 21 /88
010-296