Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita BO4565 Bedienungsanleitung

ENGLISH
1-1. Switch
2-1. Velcro sandpaper
2-2. Base
3-1. Velcro sandpaper
3-2. Base

SPECIFICATIONS

Orbits per minute (min
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-4:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 85 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745-2-4:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
EC-DECLARATION OF CONFORMITY
Model; BO4565
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
Explanation of general view
4-1. Base
4-2. Velcro sandpaper
5-1. Dust bag
6-1. Groove
6-2. Front fixing cardboard
Model
Pad size
-1
)
Net weight
Safety class
) : 81 dB(A)
pA
value (tri-axial vector
2
) : 4 m/s
h
2
CE2007
ENE052-1
000230
ENF002-1
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENG101-1

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to sander safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious personal
injury.
1. Hold power tools by insulated gripping
surfaces when performing an operation where
ENG211-1
the cutting tool may contact hidden wiring or
sum)
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
2. Always
Ordinary eye or sun glasses are NOT safety
ENH101-8
glasses.
3. Hold the tool firmly.
4. Do not leave the tool running. Operate the tool
only when hand-held.
5. This tool has not been waterproofed, so do not
use water on the workpiece surface.
6. Ventilate your work area adequately when you
perform sanding operations.
7. Some material contains chemicals which may
be toxic. Take caution to prevent dust
3
6-3. Front side of paper dust bag
7-1. Claws
7-2. Upper part
8-1. Notch
8-2. Guide
BO4565
112mm×190mm
14,000
219 mm x 112 mm x 139 mm
1.1 kg
/II
Tomoyasu Kato
Director
use safety glasses or goggles.
GEB021-1