Cebora PLASMA SOUND PC 110/T Betriebsanleitung Seite 25

particular material can be used different currents cutting.
If prevail productivity needs, set the maximum allowable
current and the speed in the column V production.
Before making any adjustments, verify that:
• the torch is perpendicular to the cutting plane.
• electrode, nozzle and nozzle protection are not worn
out and that their combination is responsive to the
chosen work.
• the cutting direction, in function of the shape to be
obtained, is correct. Remind that the best side of a
cut is always the right with one respect to the torch
motion direction (the plasma used has diffuser holes
in a clockwise direction).
If you need to cut high thicknesses, particular attention
PROBLEM
Electrode or nozzle worn out
Oblique cutting Stand off too high
Cutting speed too high
Cutting speed too high
Nozzle diameter too large compared to the
current set
Insufficient
Excessive plate thickness in
penetration
processing compared to the current set
Ground wire not in good electrical contact with
the cutting plane
Cutting speed too low
Presence of
"low speed
Cutting speed too high
dross" *
Stand off too low
Presence of Cutting speed too high
"high speed
Cutting speed too low
dross" **
Stand off too high
Cutting speed too high
Rounded cut
edge
Stand off too high
* The low speed dross are thick dross, of globular shape, easy to remove. The kerf is fairly large.
** The high speed dross are thin dross, hard to remove. In case of very high speed, the cut wall is rather rough.
should be given during the step of lead-out: in particu-
lar, when trying to remove the accumulation of molten
material around the cutting start hole, so as to avoid
double arc phenomena when the torch comes by again
to the starting point. Moerover, keep the nozzle protec-
tion always clean from molten slag which sticked.
The following table shows some of the most frequent
problems and their solutions.
CAUSE SOLUTION
Replace both
Lower stand off
Adjust speed
Adjust speed
Check cutting tables
Increase cutting speed
Check the tightness of the earth terminal to the
CNC
Adjust speed
Reduce cutting current
Raise stand off
Adjust speed
Increase cutting current
Lower stand off
Adjust speed
Lower the stand off
25